Yamamoto Sound Craft TY-1 Headshell Finger Hook

TY-1 is a finger hook for the headshell. The main body is made of lightweight and high-rigidity pure titanium, and silicone is used for the anti-slip O-ring.
General headshell finger wraps are often made of thin and soft materials such as aluminum, but this product is designed to improve sound quality by adding strength to that part.
If the headshell uses M2 size screws, it can be installed without any problems.

By replacing it with a high-rigidity titanium round rod, the rigidity of the entire headshell increases, improving the tightness of the sound and clarifying the sound image. The non-slip silicone O-ring on the tip is also removable, allowing you to enjoy the change in sound.

format	Replacement Headshell Finger Hook
Dimensions	Length 20 mm, Maximum diameter 3 mm, Thread M2 length 2.5 mm
weight	0.45g

The titanium finger strap TY-1 is hard and stick-shaped, so you don't have to worry about squealing. I listened to it normally with the company's brass finger straps, and then switched to TY-1. The sound image tightened fearlessly. At the same time, I added a faint wide-area accent attached to the brass. I was surprised by the double. So, if your finger hook is a method that is fastened with an M2 screw, this is lucky. I would like to recommend the finger-hanging "tune".
The influence of the non-slip silicone O-ring is also not ridiculous. When you put it on, it sounds quiet, and when you take it off, it sounds open. I decided to take it off.