Fidelix NON-STAT Eliminator for Record Disk

Scratch noise is attached to the record, the cause is mainly scratches and small dust. Static electricity is deeply involved in the attraction of dust, and when the needle passes over the dust attached to it, the sound becomes tight and at the same time, the sand grain may be pounded in the counterclockwise direction to the V groove.
In addition, dust is attracted to the board by static electricity, and as it proceeds to the inner circumference, the dirt accumulates in the needle, causing distortion to increase in the inner circumference. Therefore, daily care is most important to protect important records from scratch noise and distortion. The conductive brush removes electricity properly, but if the brush is not clean, instead of taking dust, dust is placed.

Before playing the record, illuminate the irradiator facing the arrow on the NON-STAT front panel toward the analog record board for 4-5 seconds from a distance of about 20 cm. In this case, please touch the copper plate part in the center of the body with your hands to maximize the power removal capacity of NON-STAT. This will help reduce scratch noise and distortion in the inner circumference, making it a must-have for watching records and digitizing.

Since it is a probe of NON-STAT internal photo and voltage waveform 10:1, the output voltage is about + 7,500V, which is 20V/div.