TAKET SUH2+ Headphones
Polymer piezoelectric Heil-type driver

Open-air (rear open type) with polymer piezoelectric heil type drive.

Function of each part SUH2+ configuration

1. a diaphragm made of bimorph polymer piezoelectric film with electrodes formed in a wavy shape is incorporated inside unit L and unit R.

2. suspend Unit L and Unit R with a single stainless steel round bar holder from the headband covered with artificial leather cover. The holder slides inside the holder base to adjust the headband head height position. It can be secured by tightening the knurled screws. The holder rotates in the holder base to automatically adjust the angle at which the ear pads rest against the cheeks.
The head cover can be replaced by opening the zipper.　The cabinets are made of ABS plastic.

3. Ear pads are made of artificial leather. The earpads are fitted into the padded base, which slides out from the unit. The earpads are replaced in one piece with the padded base.

4. The super tweeter "BATPURE" is built into the bottom of the L/R unit, and the super tweeter reflector directs the super high-frequency sound to the face. This prevents cranial localization of the sound field and creates a sense of openness.

5. Each unit is connected to a cable approximately 35 cm long, which is combined into a single cable with a Neutrik 4-pin plug attached to the end. TAKET's unique sound field activation technology, SA technology, is integrated with the cable. This technology reduces unnecessary scattering of sound when listening to headphones and creates a lively sound cohesion.

When SUH2+ is used alone

When SUH2+ is connected to TR2

NOTE; If a test signal is input for a certain period of time for measurement, the detection resistor of TR2 may heat up and the protection circuit may be activated to cut off the current. The power will be restored after a while after the power is turned off, but please use only music source.